Design and Fabrication of Multi-Side Pneumatic Modern Trailer

Authors

  • Dinesh Kumar S  Assistant Professor, East Point College of Engineering and Technology, Bengaluru, Karnataka, India
  • Senthil Vinayagam M  Student, East Point College of Engineering and Technology, Bengaluru, Karnataka, India

Keywords:

Abstract

This project work has been conceived having studied the difficulty in unloading the materials. Our survey in the regard in several automobile garages, revealed the facts that mostly some difficult methods were adopted in unloading the materials from the trailer. Now the project has mainly concentrated on this difficulty, and hence a suitable arrangement has been designed. Such that the vehicles can be unloaded from the trailer in three axes without application of any impact force. By pressing the Direction control valve activated. The compressed air is goes to the pneumatic cylinder through valve. The ram of the pneumatic cylinder acts as a lifting the trailer cabin. The automobile engine drive is coupled to the compressor engine, so that it stores the compressed air when the vehicle running. This compressed air is used to activate the pneumatic cylinder, when the valve is activated.

References

  1. G.B.S. Narang, “Automobile Engineering”, Khanna Publishers, Delhi, 1991, pp 671.
  2. William H. Crowse, “Automobile Engineering”.
  3. Mechanism in modern engineering design - S .k. Bose
  4. Elements of workshop technology - VOL II- S .k. Hajra
  5. Strength of materials - I .B. Prasad

Downloads

Published

2020-12-15

Issue

Section

Research Articles

How to Cite

[1]
Dinesh Kumar S, Senthil Vinayagam M, " Design and Fabrication of Multi-Side Pneumatic Modern Trailer, IInternational Journal of Scientific Research in Mechanical and Materials Engineering(IJSRMME), ISSN : 2456-3307, Volume 4, Issue 7, pp.67-71, November-December-2020.